Gary, The tx if is visible on the P3 when K3 baud rate is other than 38400 baud, the K3>P3 sync feature will restore 38400 after that over. Usually it requires a manual change of setting in K3 config and/or pf1 assignment to show this feature whilst rs232 is still connected, but using a baud rate mismatch to show.
cheers Adrian On 27/06/2012 20:56, Gary Gregory wrote: > *I have seen the P3 a number of times enter a state where it is showing Tx > audio without any changes being made to cabling or settings. Whilst there > is a way to monitor one transmission by disconnecting the IF lead, what I > am seeing appears for one over then stops and may not appear again for a > day or so then suddenly it returns. > > I am wondering if there is a fault slowly developing. > > If anyone can shed some light on what is happening i would appreciate it. > > I am not a particular fan of the P3 or pan adapters but as I have one I > would like to ensure that it is functioning as it should. > > Regards > Gary > * ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
