Make sure you don't have any "stuff" between the K3 Utility and the K3, like microkeyer(?) or other usb management. Just a native RS232 port or a usb-serial adapter.
Fred Cady fcady at ieee dot org > -----Original Message----- > From: elecraft-boun...@mailman.qth.net [mailto:elecraft- > boun...@mailman.qth.net] On Behalf Of Don Wilhelm > Sent: Friday, July 06, 2012 3:34 PM > To: K2GN > Cc: 'Elecraft' > Subject: Re: [Elecraft] Stuck in MCU LD > > Larry, > > Do you have a saved configuration file? If so, try an EE INIT > (Parameter Initialization) - then load the new firmware and reload your > configuration. > If you do not have a saved configuration file, you will want to contact > K3support before trying an EE Init, and you will have about an hour's > work to load all the necessary options and do the calibration steps. > > 73, > Don W3FPR > > On 7/6/2012 5:02 PM, K2GN wrote: > > Been there done that. Nothing. > > > > Larry/K2GN - http://k2gn.com > > > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:Elecraft@mailman.qth.net > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html