An ABB RXMA2-RK211-191 relay would do the job nicely powered from K3 '12v out'
-----Original Message----- From: elecraft-boun...@mailman.qth.net [mailto:elecraft-boun...@mailman.qth.net] On Behalf Of Art Nienhouse Sent: Friday, 14 September 2012 11:16 PM To: Elecraft@mailman.qth.net Subject: Re: [Elecraft] [KPA500] stuck on TX when AUXBUS attached It would be nice if the function of the AUXBUS cable could be disabled from a menu choice on the KPA500 instead of disconnecting of the cable between the K3 and the KPA500. Would this be something that could be done in the KPA500 software? Regards Art ka9zap > Tonight I tried to use my KX3 with my KPA500, but when I turn off the > K3 that it is attached to via AUXBUS, then put the KPA500 into OPERATE > mode, the asterisk comes on and it is in TX, which means that the > receiver of the KX3 goes deaf. Is this the way it is supposed to > work, or have I messed up a setting? Will I have to remove the AUXBUS > cable from the K3--even though the K3 is turned off--whenever I want > to use the KPA500 with another rig? > > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
