> A resistor network normally has one common pin; one side of each of the > resistors goes to a distinguished pin. It isn't going to work if it's in > backward.
In the KSB2, this is only true for RP5. RP1, RP2, and RP3 (there is no RP4) have two pins per identically valued resistor. It won't matter what orientation was used when the RP is soldered in. So...what RP was installed backward? > It may be less difficult overall to just cut the part out, remove the pins > one by one, and order a replacement resistor. That would be the best advice it one are unfortunate enough to have installed RP5 in backward. But if RP1, RP2, or RP3 has been soldered in backward, just let it be. 73, Mike / KK5F ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html