Yes. What Jim said too. matt
On Sun, 04 Nov 2012 08:38:12 -0500, you wrote: >Make sure as well that the flex cable is plugged in correctly. I suggest >reviewing the section of the manual. > >73 > >Jim WB8AZP > >Sent from my iPhone > >On Nov 4, 2012, at 8:15 AM, Matt Zilmer <mzil...@verizon.net> wrote: > >> Try re-seating the flex cable between RF and FP boards. >> >> matt W6NIA >> >> On Sat, 03 Nov 2012 21:03:34 +0100, you wrote: >> >>> Hi, just assembled the Kit S/N 2294 with KXAT3 and KXFL3. No problems >>> during assembly. I used anti static wristband and mat. >>> >>> Tried 12V battery and linear power supply. While pressing BAND- and ATU >>> TUNE the four LED light up. After releasing the buttons the LEDs switch >>> off and the display backlight turns on. That's all. No display, no >>> message,s no sound. Nothing. And the KX3 won't switch off. >>> >>> >>> Any suggestions? >>> >>> >>> regards >>> Holger - DL9HDA >>> ______________________________________________________________ >>> Elecraft mailing list >>> Home: http://mailman.qth.net/mailman/listinfo/elecraft >>> Help: http://mailman.qth.net/mmfaq.htm >>> Post: mailto:Elecraft@mailman.qth.net >>> >>> This list hosted by: http://www.qsl.net >>> Please help support this email list: http://www.qsl.net/donate.html >> ______________________________________________________________ >> Elecraft mailing list >> Home: http://mailman.qth.net/mailman/listinfo/elecraft >> Help: http://mailman.qth.net/mmfaq.htm >> Post: mailto:Elecraft@mailman.qth.net >> >> This list hosted by: http://www.qsl.net >> Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
