Hi Although I never got around to it, I did some measurements and the power supply will fit into the EC2 if you remove the rubber feet on the bottom of the power supply. I guess you could also remove all of the electronics and fan from the case and install it all into the EC2 and have even more room but that should nor be required. All that is needed is to cut out the back of the EC2 to fit the power supply and drill come holes in the bottom of the EC2 for air flow. There is even enough room for a K2 type battery that could be float charged from the power supply and or a solar panel with controller. This would give you a back up supply in case of a power failure to run at QRP levels. A while back someone on the list posted some pictures of the set up with the power supply in the EC2 so it has been done.
Don Brown KS5NDB ----- Original Message ----- From: <[EMAIL PROTECTED]> To: <Elecraft@mailman.qth.net> Sent: Wednesday, September 14, 2005 10:54 AM Subject: [Elecraft] Switching Power Supply in EC 2 > Don Brown KD5NDB posted (2002) an interesting proposal to install a > MFJ-4125 power supply into an EC-2 Case. Has any one attempted this > project? > > KI4DGH > Chuck G. _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com