I'm nearing the end of construction for my KAT2. I'm at the step on page 12 of the KAT2 rev. D manual that says:
"Secure the L-C board to the Control board standoffs using two 4-40 screws and two #4 split lock washers. These lock washers go between the standoffs and the PC board, not between the PC board and screws as on the control board." My question is this. Just where do these lock washers go? Page 6 of the KAT2 rev. D manual has an illustration that clearly shows the lock washers between the PC board and the standoffs. So that is what I did for the step on page 6. The last sentence in the quoted step from page 12 would seem to be in error and is what is causing my confusion. There's no illustration on page 12 for this step. One is told to put the lock washers between the standoffs and the PC board as apposed to the way it was done on page 6. It sure is a trivial point but I'd sure like to get it right. Thanks, Roger, W1EM _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com