Thanks also noted.
72
Dom
M1KTA
On 24/01/13 15:16, Don Wilhelm wrote:
Dom,
Note that there is also a XVn OFS menu entry that will allow you to
enter an offset to compensate for variations in the transverter LO and
give you the correct frequency reading in the lower order digits too.
73,
Don W3FPR
On 1/24/2013 9:08 AM, Dominic Baines wrote:
Thanks Don,
Yes agreed.... I just advised was looking at two options.
I had already been sent an email asking was this limited to KX3 only?
The answer would be no hence the "dumb" option.
UK has 472KHz-479KHz available to full licencees with a Notice of
variation to the licence.
The option equates to either operate with the KX3 in the 'normal
band' with no frequency feedback so you will need to know what the
transverter LO is set to and you need to be sure you set the output
power low or I believe you can set it to a transverter band and then
a couple of options become available, being the IF and the frequency
display (as you say). The RF out is also dropped to 0.1W by default.
A quick test seemed to show the RF out was c0.1W no matter what the
normal power level was set to but was a really quick test before had
to run as got normal day job.
72
Dom
M1KTA
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
