The KAT100 is a quick build and needs the I/O with the KPA100 for testing. Do the KPA100 first. Once that's done and tested the KAT100 will go quickly.
Craig NZ0R K1 #1966 K2/100 #4941 -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Craig Miller Sent: Friday, September 30, 2005 7:04 AM To: elecraft@mailman.qth.net Subject: [Elecraft] Build Order: KPA100 & KAT100-1 ? I presently have a K2 with KAT2 internal tuner. I do not have a KIO2 installed. I've just purchased the 100 watt amp and external tuner. My question is which order I should build and test these two units: KAT100 first but no way to communicate with it to test it, or KPA100 first with no way to use it except for a dummy load? If I build the tuner first is there a way to "tap in" to the K2 enough to get the required communication signals to check the tuner out? Any suggestions from the group? Thanks, Craig K3OOL K2 4790, KSB2 KAT2 KDSP2 (KAT100, KPA100) (Does the xyl know this??) _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com