Brian At least in my setup using NaP3. The TX signal is visible on the panadaper display with no extra cables
Ariel Sent from my iPhone On Jun 8, 2013, at 10:30 AM, "Rich Heineck" <ric...@frontier.com> wrote: > Brian, > > The TX I/Q signals are only routed internally and aren't at any external > connector, though they do have labeled test points. The I/Q connector on the > side is an RX output only. > > 73, > Rich AC7MA > > > On 06/08/2013 04:49 AM, Brian Machesney wrote: >> I would like access to the I/Q signals produced by the DSP modulator on >> transmit. Are these signals available on the rig's I/Q outputs? >> >> Brian K1LI >> ______________________________________________________________ >> Elecraft mailing list >> Home: http://mailman.qth.net/mailman/listinfo/elecraft >> Help: http://mailman.qth.net/mmfaq.htm >> Post: mailto:Elecraft@mailman.qth.net >> >> This list hosted by: http://www.qsl.net >> Please help support this email list: http://www.qsl.net/donate.html >> > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:Elecraft@mailman.qth.net > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
