It sounds like a configuration parameter got corrupted somehow in
non-volatile memory. Try doing a "Parameter Initialization" as described
in the Troubleshooting section of the manual. That is, write down your
FN key assignments and MENU parameters, then hold the LABELS key while
turning on the P3 with the POWER switch. Wait until the "CONFIGURATION
RESET" message appears on the screen and release then release the LABELS
key. (If you have the power-on jumper in the P3 configured to
always-on, then just hold LABELS and tap POWER.) Then re-enter the FN
key assignments and MENU parameters.
Alan N1AL
On 6/9/2013 2:36 PM, Chuck Guenther wrote:
I was operating today, and noticed my P3 display showing no spikes or
noise level, and the waterfall portion of the display is pink.
When I try to adjust the REF LVL, I get an indication of "nan" instead
of some negative dBm level. I've cycled the power on/off on both the K3
and P3, and even re-booted the computer, with no improvement.
TNX for any help on this,
73,
Chuck Guenther NI0C
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
