Alan N1AL, (If you have the power-on jumper in the P3 configured to always-on, )
I don't remember reading a reference to 'the power-on jumper'. I do remember something in the menu settings. Is this what you are referring to? Dick, n0ce ----- Original Message ----- From: Chuck Guenther To: elecraft@mailman.qth.net Sent: Monday, June 10, 2013 9:05 AM Subject: [Elecraft] [K3} P3 Failure? fixed! Thanks, Alan! That did the trick. (actually, I found that procedure in the P3 manual). I wish I had written down the transfer gain that I had setup during my amplitude calibration a year or two back. The gain is set to -7 dB now, which I believe is the factory default. I t was strange, though, tuning the bands for even a few minutes without the P3. I hadn't realized how much I have grown to depend on it! 73 & thanks again. Chuck Guenther NI0C N1AL wrote: "It sounds like a configuration parameter got corrupted somehow in non-volatile memory. Try doing a "Parameter Initialization" as described in the Troubleshooting section of the manual. That is, write down your FN key assignments and MENU parameters, then hold the LABELS key while turning on the P3 with the POWER switch. Wait until the "CONFIGURATION RESET" message appears on the screen and release then release the LABELS key. (If you have the power-on jumper in the P3 configured to always-on, then just hold LABELS and tap POWER.) Then re-enter the FN key assignments and MENU parameters. Alan N1AL" ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html