Version 1.16 of XG3 firmware is now available for general release. Please make sure you are using the most recent version of the XG3 utility which can be found here for PC <http://www.elecraft.com/XG3/XG3_Utility_Setup_1_13_6_6.exe> Mac <http://www.elecraft.com/XG3/XG3UtilityOSX_1_13_6_4.zip> or Linux <http://www.elecraft.com/XG3/XG3UtilityLINUX_1_13_6_4.tgz> .
This is a minor release which adds/fixes the following issues: Revision 1.16 May 28, 2013 • A break signal is now transmitted over the serial port at the start of frequency sweep and Morse memory playback. This appears as a 1.3 ms low to high to low pulse on the serial TX line and can be used to trigger external equipment. • When sending a Morse string using the ‘W’ command, pressing any key or any received serial character will now stop and exit the Morse sequence. • Fixed a bug in which the first element of the first character in a Morse string was being omitted. 73, Paul (n6hz) -- View this message in context: http://elecraft.365791.n2.nabble.com/XG3-version-1-16-firmware-now-available-tp7577887.html Sent from the Elecraft mailing list archive at Nabble.com. ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html