Just downloaded CW skimmer and am using it with the LP Pan, E MU 0202 and of
coarse the K3. I am in the process of setting things up and has some questions.
As well just wanted to share the setup options I chose just to make sure they
are ok.
Under the settings tab....and then to the radio tab
1. I have set hardware to softRock-IF (as per LP Pan site) is this correct?
2. Sampling rate I am going to use is 96 and I did set the same on the E MU 0202
3. Pitch is set to 600 as is the K3
4. The Audio IF I am not sure what to set that too as I am not running any SDR
software. The only answer I could find for the setting of the was to set the
Audio IF at -6000 and take away the global offset from your SDR software. I am
not using SDR software so is it left at -6000?
The Audio tab is set as follows.........
1. Sound-card driver is set to MME
2. Signal and Audio devices are set to my E MU 0202 cards
3. Channels was left at Left/Right= I/Q
4. Shift Right channel data was left at 0 samples
The Rig tab is set as follows..........
1. Rig K3
2. Com port to be set when I use VSP manager to set up a virtual port pair.
3. Baud 38400
4. Data 8 bits
5. Parity none
6. Stop 2
7. RTS set to High....not sure about this?
8. DTR set to high as well and not sure about this?
9. Poll set to default 500
10. Time out set to default 4000.
Not to concerned about other tabs at this moment in time. Just wanted to see if
I am on the right track with those who have this program up and running with
their K3
Thanks for your time
Mike
VE3WDM
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
