Ed,
Those early instructions were changed with firmware MCU release 2.00 and
above.
Hold any button down while you power on and the K3 will display the
firmware version briefly. If it shows MCU 2.00 or above, run CAL PLL
only on 40 meters.
Below that version, run it on each band.
73,
Don W3FPR
On 9/2/2013 12:06 AM, Eddy wrote:
I notice in early documentation on the Elecraft website they mention running
CAL PLL on each band, but in my K2 manual (Serial # 3600+) it only talks about
running CAL PLL between 7000 and 7100, the 40-mtr band.
Can someone tell me the official recommendation on CAL PLL?
Thanks much!
73, ed
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
