What a wonderful source of help this group is! Turns out the problem wasn't really a problem at all. I was loading a long-wire antenna when doing the measurements and relying on the watt meter provided by the KX1. As Don and Rick suggested, when I connect a 50 ohm DL1 dummy load and use a DMM to measure the voltage across the test points of the DL1, I see a very nice 3-4 watts on all bands (translating the voltage on the DMM to watts using the graph provided on the DL1 manual).
Phew! I'm set to go. Thank you! Dan, n0da On Mon, Sep 23, 2013 at 5:09 AM, Don Wilhelm <w3...@embarqmail.com> wrote: > Dan, > > With a 13.8 volt power supply and working into a good 50 ohm dummy load > (without the KXAT1 installed) you should have at least 3.0 watts on all > bands (I normally expect 3.5 watts or more). Measure with an external > wattmeter that is has known accuracy at low power - many wattmeters with a > 20/200/2000 watt range switch are inaccurate at low powers and will > typically read lower than the actual power. That is typical of analog > meters, many with digital readouts are not as bad in this respect. > > While 40 and 20 meters usually have lower power output than 80 or 30 > meters, yours is extremely low. > You *will* find the problem is on the Low Pass Filter board. > Check it very carefully for toroid leads that are not well tinned and > soldered. If you see any evidence of wire enamel on the solder side of the > board, that lead was not well tinned before installation and must be > re-done. > Also make certain that the green lead on L2 that routes around to the back > of the board is not contacting the red lead #4 - check both the front and > back of the board. > > You may have to remove the LPF board and re-wind the toroids. > > 73, > Don W3FPR > > > On 9/23/2013 12:24 AM, zan0416 wrote: > >> Finished a brand new KX1 this afternoon, with ATU and 3080 module. >> >> Power output with 13VDC for all bands is as follows: >> >> 80 6.3 watts >> 40 1.7 >> 30 4.0 >> 20 3.0 >> >> Clearly something is amiss with 40 meters. I read somewhere to mess with >> the green windings of L2 on the 3080 module, but that didn't seem to do >> much >> other than make it worse. The number of windings on all the toroids have >> been double-checked as correct. >> >> Anyone have any ideas where to go from here? I don't have any test >> equipment except for a DMM. >> >> Thanks for any suggests you may have. >> >> Dan, n0da >> >> > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
