Critical question: When I adjust the power level of the K2/KPA combination between low (10W) and high (100W) power is the power measurement taken at the same point for both levels?
Clearly, the RF level scale changes between the two settings. 10W is full scale below 10W, 100W is full scale above 10W. When operating below 10W is the power level measurement taken from the K2 or from the KPA? Assuming the ALC level depends on the power level measurement, a difference in the point at which the power level is measured would explain the ALC changes around the 10W level. My K2 and KPA were built and aligned by different builders and there's no reason to believe they were set exactly the same. -- View this message in context: http://elecraft.365791.n2.nabble.com/K2-KPA-ALC-problem-tp7581353p7581407.html Sent from the Elecraft mailing list archive at Nabble.com. ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
