Sounds like you have the same failure I do. Take the cover off and look for the DSP PCB and on the upper left side top is U1. Mine did not heat up or draw excessive current but was told that it might smoke smell bad and be hot to the touch. I think your U1 the audio amp is the culprit. I ordered the AF protection PCB assembly and a new IC from Elecraft. Not expensive but a bear to replace the SMD IC. Good luck
Mel, K6KBE On Saturday, December 21, 2013 9:36 AM, Marcel Jorba <ea...@yahoo.com> wrote: Hello Since today, my K3 is not producing audio on the internal speaker or via an external speaker connected to the rear speaker socket Audio is fine in my headest via the front or the rear connector Time to time I can see HI CURR on the display. I must power off and on the eliminate it Any idea? Thanks Marcel - EA3IN ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html