Sorry that should have been D16 and 17. I'm going to look at the circuit again and again. 73
K0AZ Mike Sanders EM37cd SW Missouri www.k0az.com -----Original Message----- From: elecraft-boun...@mailman.qth.net [mailto:elecraft-boun...@mailman.qth.net] On Behalf Of Mike Sanders Sent: Friday, January 03, 2014 7:13 AM To: Elecraft@mailman.qth.net Subject: [Elecraft] K2/100 7211 TX Power output meter stopped working Good Morning, Yeah, not sure what happened but appears when in high power mode over 10 watts power control does not work either. It gives full output. I just replaced diodes D1 and D2 1N5711s but the problem continues the same. Before I get any deeper into this does anyone have any experience with this failure and any ideas? I sure thought the diodes would fix this. I triple checked my work and the orientation of the diodes on the board. 73, Mike K0AZ K0AZ Mike Sanders EM37cd SW Missouri www.k0az.com ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html