Jamie,
If the KXFL3 module is installed correctly, the 1/2 inch long screw
should protrude through the KXFL3 board locking it in place. Make
certain the KXFL3 board is installed correctly into the header before
inserting the screw.
73,
Don W3FPR
On 1/11/2014 4:18 PM, James C. Hall, MD wrote:
Hello:
I received my filter board for my KX3, but the ½”, 13mm screw will not
engage the screw hole in the filter board. The screw, which is exactly the
same as the screw that was already there, barely touches the filter board
when fully installed. Is there some trick to getting this screw to work, or
should I look for a longer screw ?
73, Jamie
WB4YDL
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html