Good evening everyone, This is my first post to the list, and I have what I hope is not a stupid question.
I just finished my K2, #5149. With the exception of a missed solder joint on the thermistor board, and my brutalizing the tiny in-line choke on the bottom of the RF board, the rig came to life, and appears to be performing as expected. With just a crummy hunk of wire, that I literally threw on the living room floor, I am truly amazed at what I can hear. I have just finished building and installing the SSB mod, and I would like to use my Heil BM-10, with the HC5 element. Does anyone have any experience using this (or a similar) set-up, and if so, could you please share any details? I notice that the Heil set that Elecraft sells requires a resistor on connector P1, but I also see a reference to a Heil pre-amp in the tech notes section of the site. Thanks in advance & 73, Jim Faulkner K5ZED Rio Rancho, NM --- Jim Faulkner --- [EMAIL PROTECTED] _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
