Sorry Bill and all--I was describing the behavior when on CW. I more often use these adjustments on CW, but if it is important for understanding the question (and for me to understand what's going on!) I will check with SSB when I get home this evening.
Thanks, Scott AA0AA >________________________________ > From: bill conkling <n...@widomaker.com> >To: Scott Monks <cq_dx_de_aa...@yahoo.com> >Sent: Tuesday, February 11, 2014 9:55 AM >Subject: Re: [Elecraft] [Elecraft_K3] curious behavior of the K3/P3, etc. > > > >On question 2, what band? On LSB bands, HiCut is the lower freq edge as its >the farthest away from the center carrier, hence higher freq audio. > > >...bill nr4c > > >Sent from my Verizon Wireless 4G LTE DROID > >Scott Monks <cq_dx_de_aa...@yahoo.com> wrote: > >Now before you guys think I too am complaining--no, I just have a curious mind! > >Two questions that I am sure you more experienced can help me with: > >1. When I begin narrowing the DSP down, on filter 1 (2.7, std, offset -0.84) >only the lower freq side moves. The DSP switches to the 2.1 filter, reacting >the same, but when it narrows to about 1.10 (within filter 2; 2.1, offset 0.0) >it changes so that both low and high move equally. Even narrowing continues >through the 700 and 400 Hz filters. The reverse occurs in the same way. I >have checked the offsets with the K3 program, and they are set as required. >On the K-3 display the "bar-thing" always seems to move equally on both sides. > Is this normal? > >2. When seen on the P-3, on hi-cut-lo, if I move the lo side, the higher freq >side moves, and if I move the hi side, the lower freq side moves. On the K-3 >display the expected side moves. Again, is this normal? > >I have the last production software installed. This was first noticed when I >got the P3 and a "big screen", when in a contest I wanted to shift the >receiver up to avoid a disturbing signal and found I had to move the hi side >to move the lo side! Now I am accustomed and just watch my screen to make >sure I am moving outside of the interfering peak. > >These only "bother" me because I know there must be a reason but I don't why >it happens! If curiosity is going to kill the "cat", don't tell me and I will >just continue to be happy with my partial K-line! > >Thanks for your patience, >Scott AA0AA >______________________________________________________________ >Elecraft mailing list >Home: http://mailman.qth.net/mailman/listinfo/elecraft >Help: http://mailman.qth.net/mmfaq.htm >Post: mailto:Elecraft@mailman.qth.net > >This list hosted by: http://www.qsl.net >Please help support this email list: http://www.qsl.net/donate.html > > > > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
