Switch to the transverter band you setup using the BAND up/dwn buttons.
When you see 334.076.00, move the VFO clockwise to pass the 0.000 point
and continue upwards.... if you're headed for 475 kHz territory, set the
VFO to Course tuning to get there faster.
DON'T enter direct frequency, doing that will change the freq. of the
160M band slot, it just doesn't work the way you are expecting. That is
why when you move down after entering the freq. you hit a wall at 490
kHz. For now, if you have a frequency in the transverter band to QSY
to, move there with the VFO.
Running the 10 MHz IF here with dual diversity RX and TX. Currently
running a side-by-side digital mode TX test tonight around 475.5 kHz.
GL 73 Eric NO3M / WG2XJM
On 02/12/2014 11:09 PM, Jim AB3CV wrote:
Also switching to 160 and back again reverts to 334.076.00 odd display.
jim ab3cv (chasing V26M...)
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html