If you look at the signal on Spectrogram or something similar, you'll see there is a different in the signal-to-noise ratio as you adjust L34 as well. The best S/N seems to coincide with the very broad peak, however.
I've most often described that peak as "subtle". Ron AC7AC -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Vic K2VCO Sent: Thursday, November 24, 2005 9:14 AM To: [EMAIL PROTECTED] Cc: elecraft@mailman.qth.net Subject: Re: [Elecraft] K2 IF Alignment question [EMAIL PROTECTED] wrote: > Happy Turkey Day to all, > > Symptom: In aligning the IF Amp on K2 #5091, I am not hearing any > signal strength variation when adjusting L34 per the instructions on > pg. 62. The weak signal near 7000 khz is relatively loud but moving > the slug doesn't result in any variation that I can hear. There is very little variation when adjusting L34, but you should notice it. The peak is usually quite close to the top of the slug's travel. -- 73, Vic, K2VCO Fresno CA http://www.qsl.net/k2vco _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
