Well, that *would* give the result you posted! Good for you, Mike. 73, matt W6NIA
On Tue, 4 Mar 2014 11:23:29 -0500, you wrote: >Thanks Matt - > >For my setup RTTY uses AFSK A, PSK uses DATA A. > >The problem (red-faced) was VOX Gain was zero. > >73, Mike > >On Mar 4, 2014, at 9:51 AM, Matt Zilmer <mzil...@roadrunner.com> wrote: > >> Hi Mike, >> >> If you're using external sound for your data modes, you should have >> the mode set to DATA A, not AFSK A. Having your audio set to Line in >> DATA A mode is correct, unless you're going through the mic and phones >> jacks. Most people use the line in/out for external data modes (very >> handy!). >> >> For keying, see CONFIG:PTT-KEYT. You can use DTR or RTS to key the >> K3. You can also enable VOX, but there will be a slight start up >> delay before the rig enters TX (probably not enough to worry about). >> >> 73, >> matt W6NIA >> >> On Tue, 4 Mar 2014 08:32:27 -0500, you wrote: >> >>> I started to play with RTTY this morning, and cannot get the K3 to transmit. >>> >>> The K3 is set for AFSK A, 2125 170. Vox is on. Monitor level is 15. CW >>> works FB. >>> >>> The computer is a MacBook Pro pushing an iMic set for line level. I can >>> hear the output from the iMic if I plug fones into it. >>> >>> The RTTY program is CocoaModem 2.0. >>> >>> What have I missed/mis set? >>> >>> 73, Mike NF4L >>> >>> >>> ______________________________________________________________ >>> Elecraft mailing list >>> Home: http://mailman.qth.net/mailman/listinfo/elecraft >>> Help: http://mailman.qth.net/mmfaq.htm >>> Post: mailto:Elecraft@mailman.qth.net >>> >>> This list hosted by: http://www.qsl.net >>> Please help support this email list: http://www.qsl.net/donate.html >> Matt Zilmer, W6NIA >> -- >> "Give me six hours to chop down a tree and I will >> spend the first four sharpening the axe." -A. Lincoln > > >______________________________________________________________ >Elecraft mailing list >Home: http://mailman.qth.net/mailman/listinfo/elecraft >Help: http://mailman.qth.net/mmfaq.htm >Post: mailto:Elecraft@mailman.qth.net > >This list hosted by: http://www.qsl.net >Please help support this email list: http://www.qsl.net/donate.html Matt Zilmer, W6NIA -- "Give me six hours to chop down a tree and I will spend the first four sharpening the axe." -A. Lincoln ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html