The P3 reads the K3 preamp and attenuator settings and adjusts its gain
accordingly for accurate amplitude display. The K3 can be set to either
take ATT/PRE into account to keep the S meter reading the same, or not,
depending on the SMTR MD menu setting. If set to NOR, that can be one
reason (among several) for differences in K3/P3 S-meter readings.
Alan N1AL
On 04/01/2014 11:19 AM, Phil Wheeler wrote:
How are Pre and ATT set? As I recall mine matches only with ATT on and
Pre off, but I've not looked lately.
Phil W7OX
On 4/1/14, 11:54 AM, Bud Governale wrote:
My P3 always matched S meter signal level to the K3.
This morning with the S0 on the K3 ( with antenna disconnected) the P3 is
displaying a level about 7 db below the S0 level.
With antenna connected the K3 shows S7 while the P3 level on the
screen is
slightly below S0.
What happened and how do I fix this?
73,
Bud W3LL
w...@arrl.net
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to n...@sonic.net
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to arch...@mail-archive.com
