Not seeing it here, Phil. KAT firmware 1.63 73, Fred KE7X
> -----Original Message----- > From: elecraft-boun...@mailman.qth.net [mailto:elecraft- > boun...@mailman.qth.net] On Behalf Of Phil Hystad > Sent: Sunday, April 13, 2014 3:02 PM > To: Elecraft > Subject: [Elecraft] KAT500 Problem --- switching antennas > > Ever since the most recent KAT500/KPA500 firmware updates, switching > between antenna 1 and 2 shows funny behavior. > > For example, on the 20 meter band I have two antennas: > > Antenna #1 -- Wire 80-meter Dipole (ladder line fed) > > Antenna #2 -- Hex beam > > So, I am positioned on antenna #2 for 20 meters. I switch manually > with the KAT500 to antenna #1. This works fine. Then, when I switch > from #1 back to #2, the KAT500 briefly goes to #2 enough to light up > the #2 LED but then immediately bounces back to #1. Now, if I switch > again from #1 to #2, there is no bounce back and everything is fine. > > This problem is totally repeatable. Always on a bounce the first > attempt to return to #2 from #1 but the second time (done immediately) > works fine without problems. > > Anyone else see this behavior. > > 73, phil, K7PEH > > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:Elecraft@mailman.qth.net > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to fc...@ece.montana.edu ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to arch...@mail-archive.com