I had just noticed those lines but didn't think they were necessarily the transmit freq as I was in CW and the line wasn't at 600 as I would have expected. Figured it was new for something but did not further research them at the time. I had my width wide to see the pileup and with it in the middle, no help.
I am new at split. Can I run split using my second receiver for the transmit freq?? Then narrow the receive width on the transmit frequency vfo so the line would be where it belongs??? Thanks, 73, Jim KG0KP -----Original Message----- From: Jim Rogers [mailto:jim.w4...@gmail.com] Sent: Friday, April 18, 2014 6:33 AM To: Jim Miller Subject: Re: [Elecraft] K3 - Transmit signal monitor display on my P3 - show location when split It does. VFO A is the green line and VFO B is the cyan line, If you are on SSB it also shows the pass band as either upper or lower sideband by which side of the marker it is on. CW will be centered in the pass band. 73s JIm, W4ATK On 4/18/2014 6:15 AM, Jim Miller wrote: > I want my signal to show me on my P3 where I am transmitting split. > 73, Jim KG0KP > > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:Elecraft@mailman.qth.net > > This list hosted by: http://www.qsl.net Please help support this email > list: http://www.qsl.net/donate.html Message delivered to > jim.w4...@gmail.com > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to arch...@mail-archive.com