Assuming the list below is the K3 barefoot into a
dummy load (and not the AL1200 driven by the K3),
how much drive does the AL1200 specify?
Phil w7ox
On 5/8/14, 1:48 PM, Greg Leber wrote:
Today when I tried to drive my AL1200 amp I found the K3 was not putting
out enough power. It drives the KPA500 fine but that only requires about
20W. I hooked it to a dummy load and this is what I found.
10m 66w
12m 103w
15m 80w
17m 88w
20m 94w
30m 106w
40m95w
80m 87w
160m 91w
I did the Xmit gain calibration using the utility and I have no error
messages. The finals must be OK because I have over 100w on two of the
bands. Do anyone have any Idea what's going on here?
Greg (K9ON)
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to arch...@mail-archive.com
