Larry,
One thing to try is to tuck the ribbon cable and speaker cable to the
KPA100 up into the space between the top of the Control Board and the
KPA100. Remove the right side panel to easily do that. The object is
to route those wires as far away from the KSB2 board as possible.
73,
Don W3FPR
On 5/15/2014 11:45 AM, Wolfgang, Larry, WR1B wrote:
Hi All,
I am looking for some suggestions on troubleshooting an SSB audio problem with
my K2 (Ser # 495). With about an hour to go before the end of the W1AW/1 CT
operation, I was on 20 m SSB and received a report of very distorted audio. At
first I blamed it on the fact that the calling station was well off my transmit
frequency. When a second caller also mentioned bad audio. I asked him to tell
me more. He thought it sounded like a bad mic or something, so I swapped out my
Heil Gold Line mic for my Heil headset. No difference. Then I went to the
Kenwood hand mic that I use for casual operating. Again, no difference. Since
he also seemed to be a bit off my frequency, I tried tuning him in with RIT. I
realized I could not tune him in for clear received audio, either. So clearly
my K2 has developed a problem.
I imagine it is something in the KSB2 SSB adapter. Any suggestions as to what
might go suddenly wrong with the adapter? Or other suggestions as to the source
of the problem?
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to arch...@mail-archive.com
