When you use the high power setting on the K3, the most obvious solution is to change the transverter to a single RX/TX IF connection. If that is not possible, connect the RX IF line from the transverter to the RX ANT input and select the RX antenna for that transverter band.

73,
Don W3FPR

On 6/15/2014 10:28 AM, g3yjr wrote:
I have connected the receive line from the transverter to the Transverter In
BNC connector on the back of the rig. When I set that transverter to a low
power setting the receive works fine, but there is insufficient power to
drive the separate transmit line to the transverter.

When I choose H2.5W, I can drive the transmit via the Ant1 socket, but the
Transverter In socket seems disabled, so recieve no longer works.

How do I configure the K3 so that I get 2.5W drive out and a separate
receive IF line which works?



--
View this message in context: 
http://elecraft.365791.n2.nabble.com/Interfacing-an-old-MM-transverter-tp7590240.html
Sent from the Elecraft mailing list archive at Nabble.com.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to w3...@embarqmail.com


______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to arch...@mail-archive.com

Reply via email to