I assume you also have the KAT3. The sub-rx can either be hooked up to the KAT3 or the AUX RF(bnc) connector, but not both. When done, there is a TMP cable that is connected to the KAT3 or AUX RF and one of the two is not connected to the sub-rx. You might have missed the step where you attached that "extra" cable to its chassis connector. See Fig. 4 on page 43 in the owners manual. Unless you plan to have a receive-only antenna, the dotted line is normally not attached to your sub-rx.
Eric WB7SDE On Mon, Jun 16, 2014, at 11:11 AM, N1IX wrote: > I just completed assembling a K3 with the sub-receiver option. > > I have an extra 12" TMP cable and I can't figure out where it goes. > > The K3 and sub-rx seem to work correctly. > > > > Dave N1IX > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:Elecraft@mailman.qth.net > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to e...@evross.com -- Eric Ross ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to arch...@mail-archive.com