Try a parameter initialization. While holding the LABELS key, tap the
POWER switch, which will turn the P3 on if it was off. After about 2
seconds you should see "CONFIGURATION RESET" on the screen and you can
release the LABELS key.
Alan N1AL
On 06/24/2014 08:33 PM, Hisashi T Fujinaka wrote:
Well that was pleasant. I was making a band change (chasing W1AW/3 and
W1AW/9) and my P3 with P3SVGA went into a screen that said something
like "Ready to load Firmware." I tried to load the firmware but at the
power-cycle I got the screen:
=====
**** FATAL ERROR ****
In: ddc_set_coef()
span=0
Press any active key to escape
=====
I tried again, and the same screen appeared.
None of the keys did a thing. So I power cycled again and saw the same
screen. I thought removing the P3SVGA might help but reloading and
resetting gave the same error.
What next?
Thanks.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to arch...@mail-archive.com
