I now see I have an error message on the remote side: Saved error message: Data Abort at 0x00043114, called by 0x000437ac
Any ideas? ---- KE8G <k...@cox.net> wrote: > Well, the unfortunate part is that the only description I got was the radio > sounded like it has a defect, nothing more and the fellow was gone. If > someone would like to setup a sked to have a listen, that would be great. It > would have to be a CW sked, as I do not have a mic. > > To update everyone commenting, I have updated the K3 firmware at the control > end, so both are now at the same level. The firmware on the RemoteRig units > are identical, no changes had been made there. The coax for the remote > station is all new 400Max series fromDXEngineering, which was thoroughly > tested when installed two months ago. > > I will update the RemoteRig firmware at both sites and see if that changes > anything. > > Thanks all for you comments! > 73 de Jim - KE8G > > Sent from my iPad > > > On Aug 4, 2014, at 11:05 PM, Mike va3mw <va...@portcredit.net> wrote: > > > > What is the actual problem? Defect doesn't really describe anything. > > > > I would check the readme and see if both ends need to be updated. I would > > suspect so. Why not upgrade the other end just to be sure. > > > > Btw, SWR being good or bad won't really tell you much other than if your > > coax is presenting a 50 ohm load. It certainly won't create a bad audio > > situation. > > > > Mike va3mw > > > > > > > >> On Aug 4, 2014, at 10:22 PM, Jim - KE8G <k...@cox.net> wrote: > >> > >> Hi All, > >> I seem to be having a problem with my RemoteRig operation. Everything > >> worked perfectly when I initially set it up. While at the remote QTH, the > >> only change I made was to add the newest firmware to the K3. I have not > >> updated the firmware at the K3 control station, would this cause a > >> problem? > >> > >> I had a person tell me the rig sounds like it has a "defect." > >> > >> Looking at things from the control end, the KAT500 & KPA500 both appear > >> fine, no changes in SWR or power output. > >> > >> Any ideas? > >> > >> 73 de Jim - KE8G > >> ______________________________________________________________ > >> Elecraft mailing list > >> Home: http://mailman.qth.net/mailman/listinfo/elecraft > >> Help: http://mailman.qth.net/mmfaq.htm > >> Post: mailto:Elecraft@mailman.qth.net > >> > >> This list hosted by: http://www.qsl.net > >> Please help support this email list: http://www.qsl.net/donate.html > >> Message delivered to va...@portcredit.net > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:Elecraft@mailman.qth.net > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to k...@cox.net ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to arch...@mail-archive.com