Make sure you power off the radio after step 4, then power it back on again before going to step 5.
Make sure you are unlocking the settings by holding in the KHz button... Jim K8JK Sent from my iPad > On Aug 16, 2014, at 9:08 PM, Louis Brown <rfe...@everestkc.net> wrote: > > I followed these steps per the installation manual rev 3A (8/13/14): > > 1) Attach power to the KX3 and tap BAND- and ATU_TUNE switches simultaneously > to turn it on. > > 2) With the KX3 on, hold the MENU switch to enter the menu. > > 3) Verified firmware is 2.12 > > 4) Turn VFO B knob to 2M/4M MODE and turn VFO A knob to nor. > > 5) Turn VFO B knob to BND MAP. Tap the BAND- and BAND+ switches as needed to > display 144 for the 2 meter module or 70 for the 4 meter module, and then > turn the VFO A knob, if needed, to display In. > > Step five is where I’m having the problem. There is no 144 band, it jumps > from 50.0 back to 1.8. Does the module tell the KX3 micro-controller what > band it is; i.e. 2m or 4m? Perhaps it’s not communicating. > > Thanks, > Lou > KD4HSO > > > > >> On Aug 16, 2014, at 5:58 PM, John K7JLT <k7jltex...@gmail.com> wrote: >> >> I had a similar problem and found after I went through the configuration >> step one-by-one and crossed them off as I completed each step. Found that I >> was skipping the same step, worked correctly the last time. >> >> John K7JLT >> >> Louis Brown <rfe...@everestkc.net> wrote: >> >>> I installed the 2m module per the instruction revision A3. When I go to >>> configure the BND MAP I’m not getting a choice for 144; it is missing when >>> I cycle through with BAND+ or BAND-. >>> >>> I verified the following settings: >>> >>> 2M/4M = nor >>> FW_REVS = 2.12 >>> >>> I reset the EEPROM to default values but that does not fix it. >>> I’m getting power to the 2m module. >>> >>> Any idea what’s wrong? >>> >>> Thanks, >>> Lou >>> KD4HSO >>> ______________________________________________________________ >>> Elecraft mailing list >>> Home: http://mailman.qth.net/mailman/listinfo/elecraft >>> Help: http://mailman.qth.net/mmfaq.htm >>> Post: mailto:Elecraft@mailman.qth.net >>> >>> This list hosted by: http://www.qsl.net >>> Please help support this email list: http://www.qsl.net/donate.html >>> Message delivered to k7jltex...@gmail.com > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:Elecraft@mailman.qth.net > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to jameskvoch...@me.com ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to arch...@mail-archive.com