From: KD3TB [mailto:idar...@gmail.com] Sent: Thursday, September 25, 2014 6:07 PM To: 'Elecraft Reflector' Subject: KAT500 Firmware Problem
I had a problem when I installed the latest version of KAT500 Software (1.67) and not sure what happened? I had been operating for a few hours on RTTY and CW with my K3, KPA500 and KAT500 with the previous version of the KAT500 Firmware (1.63). After a while, I checked for new versions of firmware on the Elecraft site and downloaded the latest version of KAT500 Firmware (1.67) and installed. I also installed the latest version of K3 and P3 Firmware. At this point I could no longer find a tune point and even on Bypass was getting a high SWR? This was happening on antenna's that have a low (1:1.2) SWR. I then reinstalled the previous version 1.63. Disconnected all power to the KAT500 , after a few minutes, reconnected power to the KAT500 and turned the power back on. At this point everything was working fine..no problems. I am not sure what happened? Firmware did not install properly? Any suggestions? Irwin Darack - KD3TB ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to arch...@mail-archive.com