Hi all, An interim release of K3 firmware is available with the following changes:
* * * K3 MCU 4.92 / DSP 2.83, 10-14-2014 * PSK63 MODE ADDED: To select PSK31 or PSK63, first tap either end of the MODE switch to select DATA, then hold the DATA MD switch and use VFO A to select the desired PSK data rate. * KAT500 POWER-ON MESSAGE SHOWN ON K3 DISPLAY: If a powered-off KAT500 is pulling the auxBus signal low when the K3 is first turned on, "TURN ON KAT500" is displayed. Previously this condition would lock up the K3 without explanation. * K3/0-MINI TX NOISE REDUCTION: Polling by Remote-Rig units is suspended during PTT or XMIT switch use to reduce a "ticking" noise heard in some cases. * * * (Other changes were made to this release that have no effect on operation, but require full re-testing of the K3 in all modes.) If you're interested in loading and testing this firmware, please contact me directly (not via a list posting). Thanks, Wayne N6KR ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to arch...@mail-archive.com