Dave,
When the K1 detects a 2 band board, it will only show b1 and b2. You
will have to set those two parameters each time you change the board.
The frequency offsets are remembered for each band, so unless there is a
duplication of a band between the two boards, you will not have to
change the offsets.
73,
Don W3FPR
On 11/17/2014 1:06 PM, w1dwz w1dwz wrote:
Thanks to all who have helped me here on the Reflector , maturing as a
ELECRAFT "Newbie "
One more query.
Using ( 2 ) 2 -channel filter boards , instead of the 4 channel
board which is no longer available , I am confused as to how to configure
the channel #'s of them.
It seems to me that each board should be set up with b1 and b2 on
each board and not b1 , b2 on one board , and b3 , and
b4 on the other . Is that a good assumption ?
the manual is a little sketchy on this.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to arch...@mail-archive.com