Arlen, Can’t hemp you with anything to do with HRD/DM780, but I can tell you what I told Ian (KM4 ). Here is a snippet of my note to him:
Here’s how mine is set up: USB connector on the back: I wound mine through four Mix 31 2.5” ferrite cores before routing it to the USB port on my iMac - just to be sure there was no RFI entering either the computer or the sound card. Probably didn’t need to do this, but there is no RFI issue for me at this point. Line Out: the Tascam has two RCA jacks (L/R). I have a cable with RCA plugs on one end and a 3.5mm stereo plug on the K3 end. Left to the 3.5mm tip, right to the 3.5mm ring. Line In: Tascam has two RCA jacks (L/R). I have a cable with RCA plugs on one end and a 3.5mm stereo plug on the K3 end. Left to the 3.5mm tip, right to the 3.5mm ring. No other connections needed. For my setup, on the Tascam, the MIC and INST controls are all the way counterclockwise. The LINE, COMPUTER and OUTPUT controls are about the 3:00 position. My K3’s Line/Mic is set to 15. Hope that helps….. 73, Jim / W6JHB > On Friday, Dec 26, 2014, at Friday, 5:42 PM, Arlen Fletcher > <arlenfletc...@mac.com> wrote: > > Santa dropped off a TASCAM US-125M at my house yesterday. All is good, except > I'm perplexed with the settings on the K3. I'm using line out on the K3 > (stereo) into the line inputs on the 125M. I have the line level cranked all > the way up to 100, but the input level on DM780 (Ham Radio Deluxe) shows an > input level of about 29. I'd expect more signal than this. If I run the > signal from the K3 line output into the mic input on the 125M I can easily > overload the 125M. > > Shouldn't there be a better signal on the K3 line out? > > Thanks in advance for any thoughts on this. > > 73, Arlen - AA7F > > > >> On Nov 22, 2014, at 09:45, James Bennett <w6...@me.com >> <mailto:w6...@me.com>> wrote: >> >> Ian - FWIW - I replaced my SLUSB several months ago with a TASCAM US-125M >> external USB sound card. Got it on Amazon.com <http://amazon.com/> >> <http://amazon.com/ <http://amazon.com/>>. Selling the SLUSB on eBay paid >> for the TASCAM unit. I have it connected to my 27” iMac and use it for >> PSK31, JT65, JT9, and an occasional RTTY QSO. No jumpers to fiddle with, no >> special cables - simple cables with RCA connectors. Couldn’t be happier with >> it. The TASCAM units are also recommended on the K9AY web pages. >> >> 73, Jim / W6JHB >> Folsom, CA >> >> >>> On Saturday, Nov 22, 2014, at Saturday, 8:44 AM, Ian - Ham >>> <km4ik....@gmail.com> wrote: >>> >>> I've been trying to get back into the digital modes, and am discovering that >>> the sound card built into my PC probably isn't adequate to the task (lack of >>> adjustable settings in terms of equalization/balance). The old EMU0202 that >>> everyone recommends isn't available any longer, and a search of eBay this >>> morning turns up none being offered there at the moment. I have a SignaLink >>> USB, which is currently configured for use with my FT-817 when I'm operating >>> portable, and I don't want to have to reconfigure it every time I want to >>> use a different rig. >>> >>> >>> >>> So, my question is this - What else are people using as an external USB >>> sound card with their PCs and the K3? I have an HP desktop with Windows 7. >>> The computer doesn't have room inside for another internal sound card due to >>> other expansion boards I put into it. :) >>> >>> >>> >>> Thanks and 73, >>> >>> >>> >>> --Ian >>> >>> Ian Kahn, KM4IK >>> Roswell, GA EM74ua >>> km4ik....@gmail.com <mailto:km4ik....@gmail.com> >>> 10-10 #74624, North Georgia Chapter #2038 >>> K3# 281, P3 #688, KPA500 #1468 >>> >>> >>> >>> >>> >>> --- >>> This email is free from viruses and malware because avast! Antivirus >>> protection is active. >>> http://www.avast.com >>> ______________________________________________________________ >>> Elecraft mailing list >>> Home: http://mailman.qth.net/mailman/listinfo/elecraft >>> Help: http://mailman.qth.net/mmfaq.htm >>> Post: mailto:Elecraft@mailman.qth.net >>> >>> This list hosted by: http://www.qsl.net >>> Please help support this email list: http://www.qsl.net/donate.html >>> Message delivered to w6...@me.com >> >> ______________________________________________________________ >> Elecraft mailing list >> Home: http://mailman.qth.net/mailman/listinfo/elecraft >> <http://mailman.qth.net/mailman/listinfo/elecraft> >> Help: http://mailman.qth.net/mmfaq.htm <http://mailman.qth.net/mmfaq.htm> >> Post: mailto:Elecraft@mailman.qth.net <mailto:Elecraft@mailman.qth.net> >> >> This list hosted by: http://www.qsl.net <http://www.qsl.net/> >> Please help support this email list: http://www.qsl.net/donate.html >> <http://www.qsl.net/donate.html> >> Message delivered to arlenfletc...@mac.com <mailto:arlenfletc...@mac.com> ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to arch...@mail-archive.com
