Don,
If you have the new encoder (with the encoder board), you have the 6mm
shaft. The old encoders have a 1/4 inch shaft.
You can tell which encoder you have by removing the VFO knob. Look to
the right of the encoder shaft and you will find a small hole in the
front panel metalwork. If that hole is empty, you have the new
encoder. If instead you see a green pin in that hole, you have the old
encoder.
73,
Don W3FPR
On 1/3/2015 2:12 PM, Don Baucom wrote:
I am going to order a VFO knob from the 73cnc site, I need to determine if I
have a 6mm or 1/4 inch dia encoder.
I tried to measure with my cheap plastic ruler. 6mm is too close to 1/4 for
me to be sure.
I have #7621 purchased 12/16/11.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to arch...@mail-archive.com