Hi Phil,
While most commands are available in the programming interface, none of the
DSP commands are, neither is there any published means to load the firmware.
Tom
-----Original Message-----
From: Phil Hystad
Sent: Monday, February 16, 2015 11:27 AM
To: Elecraft Reflector
Subject: [Elecraft] K-Line Programming
Question about programming interface for all the K-Line equipment (including
P3 and KAT500)…
Are the published programming commands totally complete? In other words, is
the published interface sufficient to rewrite all functions of the
K3/P3/KPA500/KAT500 utility programs including the firmware updates?
73, phil, K7PEH
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to tom...@videotron.ca
---
This email is free from viruses and malware because avast! Antivirus protection
is active.
http://www.avast.com
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to arch...@mail-archive.com