Yes, but the inductances are all in parallel. I built a decent dummy load
out of 24, 1200 Ohm, 10 watt wire wound resistors all in parallel between
two squares of fiberglass PC board. The SWR was only about 1.2:1 on 15
Meters and about 1.5:1 on 10 meters. Admittedly, not a perfect load, but
certainly adequate for the low bands just to soak up some RF.
73, Charlie k3ICH
If you're going to use the paralleled metal film resistor construction
method, be sure to keep the resistor leads short and spaced them from each
other. Lead inductance will start to become a factor on 6 m and up. I
built mine with 40 2K 2W resistors and it works find at 100W if used
intermittently. It's air cooled. Don't know how much putting it in oil
would improve the dissipation.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to arch...@mail-archive.com