There's a procedure described in the K3 Utility Help menu under
'troubleshooting' called Forcing the K3 into "Firmware Load Required"
Mode. Follow this procedure.
73,
Vic, 4X6GP/K2VCO
Rehovot, Israel
http://www.qsl.net/k2vco/
On 21 Aug 2015 10:37, pastor...@verizon.net wrote:
I am sending this message again, as it seems my first message never
made it to the board. I was trying to load the new Firmware into my
K3. Well for some reason we had a power blip during a storm and now
my K3 is stuck in MCU LD. Right now the screen in dark when power is
applied and MCU LD is on the screen. The Red TX light is flashing and
after a period of time it will then go to the Delta F light which
will flash yellow. I cannot connect to my K3 via my computer because
I'm sure it's because it is stuck in the MCU LD error. How does one
reset their K3. I read about the EE Init where I Held in the Shift/Lo
button while pressing the Power button and nothing Plus to get the
K3 out of this state I need to shut off the power supply. Every
button is totally useless. Perhaps I need to call the people at
Elecraft once I get home from work this afternoon. Hopefully someone
on the board will have a solution or someone from elecraft will see
this message and help! Thanks! Mark Griff in, KB3Z
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to arch...@mail-archive.com
