Tuck,
Do you know for sure your dummy load is a good 50 ohm load at 6 meters?
It is always good to check that with an antenna analyzer.
Try repeating the TX Gain Calibration on 52 MHz manually from the menu.
If it completes both 4 and 6 watts without complaint, you are 'good to go'.
73,
Don W3FPR
On 9/4/2015 11:30 AM, Tuck Watkins wrote:
The problem is the KX3 TX calibration is failing on 52 MHz at 4.0 W. I
would appreciate some advice on how to proceed with diagnosis and
correction.
I attached a suitable 100W dummy load to the KX3. Then I ran the KX3
configuration utility. I executed the TX Calibration Gain. It runs fine
with no errors until it reaches 52 MHz. The relevant lines with the
failure message on the computer screen are:
Calibrating 52.000 MHz
TxGainStartTune Invalid response to "TQ;"
Calibration failed
I then decided to try the TX calibration instructions in the KX3 manual.
As with the KX3 utility all went well except for the 4.0 W at 52 MHz
test. When I got to 4.0 W on 52 MHz it appeared that the output was
stable. That is the 4.0 W was holding steady. When I pressed the button
to turn off the tuning the message in VFO A displayed was "d=017." The
message in VFO B was "ERR TXG." I repeated the test at 4.0 W. The
message in VFO B stayed the same. The message in VFO A changed to
"d=042." A third attempt produced "d=046" message in VFO A. VFO B had
the same "ERR TXG" message.
I then ran the test at 6.0 W. There was no error. The error does not
suggest what to do next. Any advice would be appreciated.
Thanks all,
Tuck, W6TUK
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to w3...@embarqmail.com
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to arch...@mail-archive.com
