Good Morning, This is Mark Griffin, KB3Z. I installed a KDVR module yesterday in which my K3 recognizes that. But I cannot get any power output or ALC when I connect my microphone to the front microphone connector. According to the service people at Elecraft they tell me that the microphone connector in the front is connected to the DSP board. And you must not have one of the pin connector seated correctly. Well, I have taken the K3 apart 4 times and put it back to together again making sure that everything is seated the way it should be and it still will not work. So I connected my microphone to the rear connector and lo and behold it gives me output power and ALC. Of course you need to use the PTT to get it to work. That is the only drawback to that theory. But, I thought I would try PSK/Rtty this morning. So I started FLDigi and connects to my K3 via Digi Keyer II, but I don't see any receive audio on the waterfall display. And I also tried MMTTY and got the same exact thing for Rtty. I did switch the mode to AFSK. Would this issue that I am having also effect the receive audio for PSK31 and also Rtty? I did write an email to K3Support this morning, but I doubt I will hear anything until Tuesday. Any suggestions/help would be very much appreciated. Mark Griffin, KB3Z ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to arch...@mail-archive.com