I think I read in one of the higher power amps write up that he uses a
company called http://www.frontpanelexpress.com/ to make his cabinets.
I'll bet it's like PCB express.
On 9/21/2015 6:21 PM, Phil Wheeler wrote:
Kevin,
At the link shown earlier there is this info: " Drawings for making
the chassis parts are here: front panel
<http://www.w6pql.com/2m/80w-amp/photo-07.jpg> rear panel
<http://www.w6pql.com/2m/80w-amp/photo-08.jpg> bottom
<http://www.w6pql.com/2m/80w-amp/photo-09.jpg>cover
<http://www.w6pql.com/2m/80w-amp/photo-09.jpg>. For heat sink
material, a heat sink with a base thickness of .300 or better should
be used. The size of the one I used was 8" long x 5.375" wide."
Not my cup of tea; not into 2 m from my location (was 20 years ago,
and broke my pick due to poor location).
73, Phil W7OX
--
R. Kevin Stover
AC0H
ARRL
FISTS #11993
SKCC #215
NAQCC #3441
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to arch...@mail-archive.com