I built a nice boom microphone switch to swap my Heil PR781 between my
K3S and my K3. The switchbox uses XLR connectors so I can use the Heil
K3 "proper" cables to each rig. I bought a regular XLR extension cable
for the mic to swithbox.
Well, I used a DPDT switch to switch both pins 1 and 2. Hum. Then I
used a 3PDT switch for switching all pins, 1, 2, 3. Hum.
Notice both Heil cables have outer shell at rig tied to mic low. Don't
wanna cut this wire, or should I?
Now all this said, I am powering each rig from a separate power supply.
My question is, before I go to the expense of purchasing a power supply
large enough to power box rigs at the same time, will this eliminate my
hum or ground loop?
Thanks in advance.
73,
Dan
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to arch...@mail-archive.com