I think I solved this...
In NaP3 there are options for polling various rig parameters [CAT
Polling]. In this section I had polling for "IF Frequency" unchecked.
Once checked, all signals stayed where they belong. Not sure what the
connection is, but it resoled the display problem. Thanks for everyone's
help. It kept me at it till I came across this item.
...robert
On 10/3/2015 21:54, Robert G Strickland wrote:
I have a K3 [w/ new synthesizer], an LP-Pan, M-Audio Delta, and running
NaP3v4. K3 filters are: 2.7/8p, 1.9/8p, 500/8p, 200/5p. Not sure "where"
this is happening, but decided to start here.
On CW, using the K3 CWT to center a signal, the pan display frequency
for the signal shifts around as follows:
Filter Freq Display
2.7 2,104cps high
1.9 1,580cps high
500 888cps high
200 1,730cps high
Note, NaP3's "global offset" is zero'd on WWV at 10MHz. I've reached a
barren bottom trying to figure this out, and I'd appreciate any wisdom
that others have to offer. Thanks.
...robert
--
Robert G Strickland, PhD ABPH - KE2WY
rc...@verizon.net.usa
Syracuse, New York, USA
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to arch...@mail-archive.com
