Hi Rich, Do the TX Gain calibration again and then retest into your dummy load on all bands. You don't need to use the amp or tuner since it's a K3 problem that you can see with your power meter.
You indicated that the overshoot occurs on the lower bands. If it only occurs on 1 or 2 bands you may need to manually touch up the results from the TX Gain Calibration on the affected bands. If the overshoot is seen on most bands then it is probably a different problem. A method is explained at the top of page 62 of the K3 manual for TXGN{pwr}. Go to the affected band, turn off CONFIG:TX ALC and set the CONFIG:TXGN number for that band to a lower number. Remember to turn CONFIG:TX ALC back on after changing the number. Retest. 73, Mike K2MK gi4doh wrote > With my K3/KPA500/KAT500 combo I occasionally get a soft or hard alarm on > the KPA500 due to the K3 briefly giving a high power burst. > I now have a digital peak power meter between the K3 and KPA500 and I can > see the surges. > The power output from the K3 is steady apart from these brief bursts. The > power will change from typically 25 to 30 watts to anything up to the full > 100 watts. The KPA500 gives a soft or hard alarm depending on how high the > burst is. > I have tried running into a dummy load and the same thing happens. > These surges are random but they appear to be more frequent on the lower > bands - with different antennas and dummy load. > The surges appear to be more likely to occur within a minute or so of > changing the power output from the K3 - either up or down. > I run the KPA500 between 400 and 500 watts to achieve 400 watts at the > antenna feed point as per UK limits. This means that I also see surges > that do not cause an alarm but briefly light the red power LEDs. > I was up to date with all firmware when I last checked about 3 weeks ago. > I have done the Tx power calibration. > Any ideas? > Rich GI4DOH -- View this message in context: http://elecraft.365791.n2.nabble.com/K3-KPA500-occasional-high-power-input-tp7609888p7609890.html Sent from the Elecraft mailing list archive at Nabble.com. ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to arch...@mail-archive.com