Hi,
That's very typical. The P3 or LPPAN for that matter will not always show
real weak signals. The waterfall as opposed to the spectrum can be more
useful here. Also, averaging,set high will help dig out the signals.
73 Tom
-----Original Message-----
From: Ken
Sent: Friday, December 04, 2015 12:55 PM
To: elecraft@mailman.qth.net
Subject: [Elecraft] P3 question - few signals show on the waterfall
I have a new P3 here connected to a K3. I can hear signals that do not
show at all on the waterfall, and barely on the upper part of the
screen. And signals that show on the P3 display do not show on the
attached VGA display.
I've gone over the Elecraft documentation and Fred Cady's booklet on the
P3 and I do not see any sensitivity adjustment for the display. There
is the level calibrate but if I move that to extremes, it throws off the
K3 and P3 showing the same signal strength. I don't think that is the
right adjustment for what I want.
Thanks
Ken WA8JXM
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to tom...@videotron.ca
---
This email has been checked for viruses by Avast antivirus software.
http://www.avast.com
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to arch...@mail-archive.com